Blog Archives

Two sets of Spiral pipe machine O.D.1220 & 630 mm Successfully Commissioned in China

2/27/2023

Equipment information:

These two sets of machines 1220×10 mm spiral pipe machine and 630×10 mm Spiral pipe machine were newly built by HUAYE recently. They were successfully commissioned and have been finished trial production in Jining ,China. The machines will be put into official production and start producing pipes from now on.

1220×10 mm spiral pipe machine

Coil width: 500-1550 mm
Pipe O.D.: Φ610-Φ1220mm
Pipe thickness: 6-10mm
Pipe length: 8 - 12m

630×10 mm spiral pipe machine

Coil width: 400-800 mm
Pipe O.D.: Φ219-Φ630mm
Pipe thickness: 4-10mm
Pipe length: 8 -12m

Equipment list in General: Uncoiler; Peeler ; Roll head straightening; Hydraulic vertical roller; Shear and butt welding device ;roll leveling machine; Delivery machine;Front bridge ;Guide plate ;Forming machine ; Inner welding device ;Outer welding device;Rear bridge ;Center support ;V-gate; Hydraulic system ; Electrical control system

Huaye is able to design, manufacure and commission the machine according to your requirements, helping you start a project at a lowest possible investment.

Please contact yang.wang@huaye.us if any further interest regarding the spiral pipe machine project.

0 Comments

For Sale-Two Sets of Used ERW Tube Mill

2/21/2023

0 Comments

FOR SALE- USED SPIRAL PIPE MILLS

2/9/2023

0 Comments

Overview:
These four used spiral pipe mills below are located in a pipe factory in Shanxi Province. Now they are for sale at low price and ready to pickup immediately.
Please contact us if you are interested. Yang.wang@huaye.us

1. Used Φ1620×20 mm Spiral Welded Pipe Mill

General Specification:
Coil width: 700～1550 mm
Coil thickness: 6～20 mm
Pipe O.D.：Φ406～Φ1620 mm
Pipe wall thickness: 6～20 mm
Pipe length: 8～12 m

2. Used Φ820×12 mm Spiral Welded Pipe Mill

General Specification:
Coil width: 450～1050 mm
Coil thickness: 3～12 mm
Pipe O.D.：Φ219～Φ820 mm
Pipe wall thickness: 3～12 mm
Pipe length: 8～12 m

3. Used Φ529×10 mm Spiral Welded Pipe Mill

General Specification:
Coil width: 450～1050 mm
Coil thickness: 3～10 mm
Pipe O.D.：Φ219～Φ529 mm
Pipe wall thickness: 3～10 mm
Pipe length: 8～12 m

4. Used Φ426×10 mm Spiral Welded Pipe Mill

General Specification:
Coil width: 450～1050 mm
Coil thickness: 3～10 mm
Pipe O.D.：Φ219～Φ426 mm
Pipe wall thickness: 3～10 mm
Pipe length: 8～12 m

Equipment list in General:
- Uncoiler
- Peeler
- Pinching& leveling machine
- Manual vertical roll
- Electric vertical roll
- Shear& butt-welding
- Delivery machine
- Pre-bending and guide beam
- Forming machine
- Front bridge
- Inside welding device
- Outside welding device
- Rear bridge
- Flying saw cutter
-Lincoln welder
- Plasma cutter
- X-ray device
- Air compressor
- Pipe transit system
-Beveling machine
-Hydrostatic tester
(Please contact us for specific equipment lists)