The 377×12 ERW pipe mill was successfully installed and commissioned in Uzbekistan.
The mill is designed to be able to produce round pipe as well as square and rectangular sections. When producing section, the mill uses "form square weld square" technology so that the majority sizes of the squares and rectangulars can be produced with one set of tooling combination. Videos attached for reference.
General Specification：
Round pipe: Φ114mm – Φ377mm
Square tube: □100×100mm-□300×300mm
Wall thickness: 4.0mm – 12.0 mm
Pipe length: Max. 6-12m (±3mm)
The mill is designed to be able to produce round pipe as well as square and rectangular sections. When producing section, the mill uses "form square weld square" technology so that the majority sizes of the squares and rectangulars can be produced with one set of tooling combination. Videos attached for reference.
General Specification：
Round pipe: Φ114mm – Φ377mm
Square tube: □100×100mm-□300×300mm
Wall thickness: 4.0mm – 12.0 mm
Pipe length: Max. 6-12m (±3mm)
Process flow :
Coil installation—Uncoiling—Blade—Head straighter—Pinching—Leveler—End shear and welder—Vertical roller—Pinching—Accumulator—Uncoiling—Blade—Head straighter—Pinching—Leveler—Cutting and welder—Planing—Vertical roller—Forming section—HF welder—Deburring—Water cooling—Sizing——Flying cut-off—Run-out table.
Please contact yang.wang@huaye.us if any further interest regarding the ERW Pipe mill project.
Coil installation—Uncoiling—Blade—Head straighter—Pinching—Leveler—End shear and welder—Vertical roller—Pinching—Accumulator—Uncoiling—Blade—Head straighter—Pinching—Leveler—Cutting and welder—Planing—Vertical roller—Forming section—HF welder—Deburring—Water cooling—Sizing——Flying cut-off—Run-out table.
Please contact yang.wang@huaye.us if any further interest regarding the ERW Pipe mill project.
RSS Feed